Thingiverse
Benchy Holders
von M4tthw
1
Downloads
0
Likes
1
Makes
Wall mountable holder for your Benchys
Comes in a 2X and 4X Holder
*IMPORTANT* When you download the STL file IF it looks super big you have to scale it down to 10.5% of it size it looks like a glitch with Thingiverse
No supports needed
Scalable? — You can but it probably wont be able to hold it :(
Recommended print settings:Layer height: 0.2 mm (0.15 mm for a better finish)
Infill: 15% or 25% for better Strength
No supports needed
Speed: 100% speed should work just fine
Material: Only PLA was tested, but others should work just as good if not better!
Comes in a 2X and 4X Holder
*IMPORTANT* When you download the STL file IF it looks super big you have to scale it down to 10.5% of it size it looks like a glitch with Thingiverse
No supports needed
Scalable? — You can but it probably wont be able to hold it :(
Recommended print settings:Layer height: 0.2 mm (0.15 mm for a better finish)
Infill: 15% or 25% for better Strength
No supports needed
Speed: 100% speed should work just fine
Material: Only PLA was tested, but others should work just as good if not better!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
