MakerWorld
Sculptures
Go to Model
Benchy Sharky
38
Downloads
35
Likes
8
Makes
Table top display of 3D benchy “Jaws” VersionAfter printing the shark, boat and the barrels you may place them as seen in the image thumbnailI also used dental floss for the ropes.Instructions for the rope tyingYou can tie first on one “CLEAT” on the rear side of the boat then go up the pole through the joint then circle around 3 times then go back in the joint then to the other cleat on the other rear side of the boat.Do it again for the front of the boat.Enjoy!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
