Thingiverse
Beskar ingot RPI Zero Case
von DarkUp
23
Downloads
14
Likes
0
Makes
Test printed on Ender 2, CR6se and Formbot Raptor.
The only printer that could not print the damasus was the Ender 2,
the raptor and the CR6se printed the damascus print when the pattern was facing up and a lot of support underneath
.
Enjoy !
The only printer that could not print the damasus was the Ender 2,
the raptor and the CR6se printed the damascus print when the pattern was facing up and a lot of support underneath
.
Enjoy !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
