Bestway pool nozzle

Made to fit the screw on fittings of the Bestway / Intex pool as ours had gone missing.

This is version 5 as I adapted it to not put too much back pressure on the sand filter. Also helps stop the pressure of the pool pump blowing the cover around as it circulates the water near the edge of the pool.

Printed at 0.2mm layer height in PLA (will see how long that lasts in chlorine water 24/7!) ... Printed using supports touching build plate only, as the thread seemed to work successfully using bridging settings. Walls were done as 1.2mm Top, Bottom & Wall thickness to give it strength.