Thingiverse
Better BMG Direct Drive Mount
by straights1x
5
Downloads
5
Likes
0
Makes
Sits the extruder closer to the hot end than the others. Uses less material and requires less support than the others. Has no unnecessary walls or features. Doesn't obstruct your hotend setup.
The 2 holes the screws go through are intentionally tight. If they are loose, the extruder will wobble. You can heat up those metal cylendar spacers and push them into the holes if they are too tight. The mount should sit flush against the bracket, the metal spacers should poke out the back a tiny bit to make sure the bearings are rolling smoothly.
The 2 holes the screws go through are intentionally tight. If they are loose, the extruder will wobble. You can heat up those metal cylendar spacers and push them into the holes if they are too tight. The mount should sit flush against the bracket, the metal spacers should poke out the back a tiny bit to make sure the bearings are rolling smoothly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
