Better Jet-Dry Lid

I always found it hard to fill the rinse aid reservoir of my dishwasher without spilling quite a bit and making a general mess.
I mostly blame the dumb standard lid.

I designed a replacement that is much like one of the refillable picnic ketchup container lids.

No support is needed if you print it with the nozzle pointing up.
I used a small brim just because I always do.

0.2mm layer height is advised since I made the cap retention strap 4 layers thick @ 0.2mm.

I found that putting a light crease in the cap retention strap makes it easier to operate.

I think that it seals better if you cut the Jet-Dry seal leaving material on the top to act like a gasket. This is opposed to just pulling it off.

I printed in PLA but I think that PETG would be better for bendyness and resistance to water/chemicals.
I'll probably reprint in PETG. (I don't use ABS)

It works well and fits the giant bottle of Jet-Dry pictured that Costco sells.
Not sure if it works for any other size