Bevel Box for CNC

This is a Customizer project. It creates 2D line paths which you then export as an SVG. The SVG is then imported into other software such as Easel, Carbide Create or Vectric Vcarve. It does not create the box pieces as an .STL file.

The idea is to create CNC tool paths for a 90 degree V Bit that will carve out the 10 pieces of a small box. This is done using 2 sided CNC carving which is not for the feint of heart. However, if you start the bit in THE EXACT CENTER of the work piece you can run the path and then flip the work piece end over end and re-run the same tool path.

The key to success is careful fixturing so that the work piece can be exactly flipped end over end and re-fixtured so that the center of the work piece is exactly where it was before except on the opposite side of the work piece. It is important that the ends of the workpiece be straight and perpendicular to the sides.

It sounds complicated, but if you get your work holding fixture set up correctly and