Bevel Gear Drawer Pull

Bevel Gear Drawer PullI wanted a unique drawer pull to replace the plain ones on my desk, so I came up with this one. The head is a replica of an actual 40 tooth module 1 spiral bevel gear. I added the stem and rounded the edges of the gear teeth to get rid of the sharp corners. It is shown in Flashforge Metallic Grey PETG. The print profile has 2 plates so you can choose the one for your setup. The first plate is for AMS and uses support material (in my case I used PLA as support interface for PETG. This is the recommended way to print it because it leaves the smoothest surface on the bottom side of the gear. The second plate is for those with no AMS and it uses standard Bambu Studio support settings. It requires (1) M4 heat insert. I just used 4mm long ones since they really don't need to hold a high load, but the hole is deep enough to take up to 10mm long.