Beyblade X Bit - Trans Point

The Trans Point Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.I printed this with ELEGOO Basic PLA Blue (I know its supposed to be red, but why not!) , but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well). Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…Credit to Juuni on Tinkercad.Boost MeBoost me if you would like!