Beyerdynamic Headphone Cable Clip

Two types of clip meant for holding your Beyerdynamic headphone cable in place. Tested on DT990s but these should work for all headphones in the DT line up. I haven't tested this on the Pro X series. The two .stls are slightly different, one “tight” and one “loose”. Just remove whichever you don't want from the build plate before printing. The screw hole is designed for an M3 screw, the threads of the screw should just bite into the part to give it a good hold. The “tight” clip is very snug around the headphone cable. This clip is designed to hold the cable in place meaning you can pull all of the slack to one side of the clip and the clip should hold it in place. If you don't like the idea of clamping the cable with the tight clip use the loose, this is 0.6mm wider and should allow the cable to slide through the clip freely but not fall out of the clip itself.