BIBO Touch 2 3D Printer Flexion Bracket

BIBO Touch 2 Dual Extruder 3D Printer Flexion Extruder Bracket:
Installing the Flexion Extruder isn’t too hard but does take a bit of extra work. All of the materials I used to make this work are from the 3D printer except for the electrical tape:
- The 3D printed bracket
- 2 screws from the bottom electrical plate
- 2 white plastic spacers found on the screws above
- Electrical tape
Make sure to follow the instructions and USE THE ELECTRICAL TAPE WHERE NEEDED. I am not responsible for any damage. Everything should work great if you follow the instructions.

1. The Flexion Extruder sits higher than the top of the extruder motor so you need to print the bracket to act as a spacer between the motors and the top mount. Print the bracket with the holes facing down so no supports are needed. I used a 60% infill, 3 walls, and a 0.1200 layer height.
2. Unscrew the 4 screws located on the top mount which act as spacers currently before installing the Flexion Extruder.
3. Follow the i