Bibo2 Touch Front Switch mount

I got tired of always having to reach around the printer to power it off then back on after a print finished in order to set the temps. so the hot ends would heat back up for the next print. Now I have a switch in easy reach

This was designed for a "Carlingswitch LRA911-RS-B/120N Lighted Rocker Switch" I found for $0.99 including shipping on ebay. I don't want it to light up so I wired it up for just the switch without the light.

This is also setup to work with the Bibo2 feet I made https://www.thingiverse.com/thing:2415596

Since the switch has no markings to show on from off I used a permanent marker to make a black line on the switches "ON" side.

I did have to replace the blade connector on the wire going to the power supply since the one that was on the wire was for a smaller blade (the one on the stock main power switch) than what's on the switch and therefore wouldn't fit. The old connector literally fell off in my hand anyway so it had to be replaced.