Bic Lighter - Wall Mount

I found that I was always looking for a lighter when I would go out to smoke, so I decided to make a screwable mount to keep where I typically smoked so a lighter was always there. This works perfectly during warmer months; however, the lighter won't work when it is too cold for the butane to evaporate. The garage and deck are perfect places for this print, mine is on the deck under the rail to protect it from weather.-Density doesn't matter much as the walls aren't very thick, but I printed mine at 50% infill anyways.-The hole it only 5mm, so supports aren't necessary.-I used a 3mm screw, any that fit will work so long as the head is flat to allow room for the lighter.-It was created for a full-size Bic branded lighter.-It is not a snug fit intentionally for easy use, and will work fine with lighters wrapped in a design (Bic uses a plastic sheathe when adding designs)-Roughly 1.5-hour print time.