Bicycle taillights

I wanted to make a rear light for my bike and this is the result

I am not responsible for any damage, explosion or injury to the model, electronics or use.

materials required:

- multi-core 24Awg cable, approx. 30cm required
- a mini flipflop circuit you made yourself, 2n2222 or s8050 can be used as transistors according to the current to be drawn, just remember that only one led will be connected to one end, short circuit the other led output.
- type c female connector module
- A red led module that draws 40mA or 100mA current (it's up to you what you want to use)
- solder
- MT3608 voltage booster module to increase the voltage from 5V to 12V (voltage should be chosen according to the led module and flipflop circuit you will use)
- 5000 or 10000mah power bank (to feed the circuit from the type c module input)
- m3 15mm ysb screw 2 pcs
- m3 10mm ysb screw 4 pcs
- m3 6 stamps
- m3 4 nuts