Thingiverse
Bicycle wall mount
door PETGore
148
Downloads
171
Likes
2
Makes
Simple wall mount for a bike with a classic diamond frame.
Pleasing to the eye because it's not tilting the bike like the other mounts on this website.
Thrilling to watch because you never know if it will snap suddenly.
The bike on the pic has about 11kg
The other pic shows a strengh test with a 5kg weight
Height is 250mm so it can be printed on the Ender 3
I highly recommend to use Cura "cubic" infill at 12%
Fusion360 source included (it is super messy, go clean it up if you like)
Post makes!
Pleasing to the eye because it's not tilting the bike like the other mounts on this website.
Thrilling to watch because you never know if it will snap suddenly.
The bike on the pic has about 11kg
The other pic shows a strengh test with a 5kg weight
Height is 250mm so it can be printed on the Ender 3
I highly recommend to use Cura "cubic" infill at 12%
Fusion360 source included (it is super messy, go clean it up if you like)
Post makes!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
