Thingiverse
Big 4 inch Seven Segment Display
por bryanandaimee
534
Descargas
532
Likes
4
Makes
It's a big seven segment display :) I used three 5mm red/orange LEDs per segment with the intent that they could be wired in series and driven straight from a micro-controller output pin. Connecting my orange LED's wired up that way to a 5V supply gave a reading of 13 mA. A micro-controller should have no trouble driving the three leds without any transistors or resistors or anything. Depending on the voltage drop of your LED's you may need a small current limiting resistor. Other colors like green and blue will likely need to be wired in parallel with current limiting resistors due to the higher voltage drop of those LED's.
I'd like to do a clock with this sometime soon. So I'll have to add an additional front plate with a clock type display instead of a decimal point.
Eventually I'll try for an 8 inch display using interlocking segments. Once the prusa is running I could do an 8 inch display all in one print. Of course the ultimate goal is a 12 inch display like evil mad scie
I'd like to do a clock with this sometime soon. So I'll have to add an additional front plate with a clock type display instead of a decimal point.
Eventually I'll try for an 8 inch display using interlocking segments. Once the prusa is running I could do an 8 inch display all in one print. Of course the ultimate goal is a 12 inch display like evil mad scie
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
