Big Brick *Gingy* Gingerbread Man

NO! Not the buttons! Not my gumdrop buttons! This is my *Gingy* Gingerbread Man. In the 3MF I&#39;ve included an alternate Head with no bite as well as alternate legs with icing stiches.The tolerances are tight in some places to ensure they stay in. May need a little glue for the gumdrops and eyes. Not recommended scaling down smaller than 80% as the tolerances will be much tighter, scaling up on the other hand is fine but will most likely need glue to keep the inserts from falling out. Designed so it can be printed without an AMS…. 3MF is optimized for minimal supports…. He stands approximately 9 inches tall Total print time is just a little over 9 hours!</