big foldable guitar stand

This is a redisign of my small foldable guitar stand. If you have a guitar with the plug at the end of the body (as a lot of acoustic guitars have) you can't use the old design. The printbed of my delta is not big enough to extend the height of the original. So I had to cut the design into pieces. Now you can print the stand on a printbed of about 10x10cm! Additional to the rod (50cm, 8mm diameter) you need 6 sticks (about 12.5cm, 3mm diameter) to plug the parts together...
Works also fine on thinner guitars (see pictures).
Enjoy...

You need a smaller stand (for your electrical guitar)? Look at:
http://www.thingiverse.com/thing:347966