Thingiverse
Big Switch SA R1 Keycap
by klackygears
33
Downloads
15
Likes
0
Makes
It's a big boy!
Used the SA Row 1 1U model from kaelruland: https://www.thingiverse.com/thing:3294107
I scaled up and adjusted the cruciform stem a bit to fit on the NovelKeys Big Switch. It's a snug fit on the stem and allows for full switch travel!
I used 10% supports and I think 20% on infill. The top comes out a little rough so it may benefit from printing at an angle and adjusting some settings.
Update 12/15/2020: Including a STEP file.
Used the SA Row 1 1U model from kaelruland: https://www.thingiverse.com/thing:3294107
I scaled up and adjusted the cruciform stem a bit to fit on the NovelKeys Big Switch. It's a snug fit on the stem and allows for full switch travel!
I used 10% supports and I think 20% on infill. The top comes out a little rough so it may benefit from printing at an angle and adjusting some settings.
Update 12/15/2020: Including a STEP file.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
