BigBox Z-Axis Bed IR Sensor Mount.

This is an alternative to mounting the IR Sensor to the Printhead. Simply replace one of the Z-Axis Drives Supports with this, wire in the IR Sensor Cable through the Heated-Bed Drag Chain, Affix the IR Sensor to the mount, bolt the two together and away you go.Perfect if you just want to use Mesh Leveling as it will give a consistent reading.Position the IR Sensor facing upwards towards the Upper Support. Print with your favourite thermoplastic | http://e3d-online.com/All-Filament Requires | 2 x M3 12mm Screws (Bag 9).2 x M3 Square Nuts (Bag 6).2 x M2.5 6mm Screws (Bag 5).2 x M2.5 Square Nuts (Bag 4). *This is untested so any feedback would be great :)Updates10-01-17 | Lengthened IR Mount to allow for Volcano.14-06-16 | Altered to lift the sensor up higher.27-05-16 | Added STP file. For news, updates, and inside information, plus options to help support my work, visit http://ko-fi.com/gregthemakerPrint SettingsPrinter: BigBox Rafts: No Supports: No Resolution: 0.25mm Infill: 20% Notes