Bigtreetech Panda PWR Interlocking Rear Mount

I wanted an easy way to mount my bigtreetech panda pwr to the back of my printer.I found a few other designs but i wasn't happy with them so i took inspiration from them and other designs like the poop chute i use that locks into the frame of the bottom of the printer and got to work in onshape. I also needed it to sit out from the back about 20mm or so as to not have interference with the poop chute leg next to it. Simply slot it under the back of the printer and slide the panda pwr into it. Also has holes for optional 8x2mm magnets, optional but recommended. Honestly think i should have used bigger and/or thicker magnets but i was working with what i had on hand and they still hold pretty well if used. Again, optional but they keep it from moving at all. And lastly to neaten things up a bit i velcro tied the power cable to the panda pwr in the configuration i have it plugged in to stop the cable sticking out. Remixes welcome. This is my first “real” cad model done in onshape (onl