BigTreeTech TFT24 Angled Case

I'm not sure if maybe they changed the board design of the TFT24 but the original case by @sdedux did not fit my display. The reset button was off by a couple of millimeters and so i hat to slightly modify the case for this print. (and yes my board also had v1.1 written on the silkscreen)

Uploading it so that hopefully i save someone else from having to to the same :D

If you are unsure if this will fit your display you could try and just print a layer or two of the case and test if the cutouts seem to match your board layout.