Thingiverse
Bike Light Mount Rail/Bracket
door spark3dprinting
23
Downloads
15
Likes
0
Makes
This is a mount I made to fix a broken locking tab on my original mount/bracket. It should work for most bike lights but it may not. I have attached the measurements for your convenience in the pictures.
Want one but don't have a printer? Get one here: https://www.ebay.ca/itm/174413088140
Note that while this is remixed from AtomicFlx's mount, it is not compatible with each other (different sizing). I have made it longer, adjusted width and sizing, added screw holes, and made it so that it was as close to 1-1 to my original broken part
Want one but don't have a printer? Get one here: https://www.ebay.ca/itm/174413088140
Note that while this is remixed from AtomicFlx's mount, it is not compatible with each other (different sizing). I have made it longer, adjusted width and sizing, added screw holes, and made it so that it was as close to 1-1 to my original broken part
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
