MakerWorld
Sport & Outdoors
Ver Modelo
Bike Pump Holder - Parametric
102
Descargas
46
Likes
57
Makes
There are 2 versions available, one with a single clip in the middle and a one with 2 clips on each side. I only tested the single clip version since my pump doesn't fit the 2 clip one. It is designed to such that you can install it along with a bottle cage. There is also a onshape document available. I recommend changing the values to see what they do if you are not sure. The ready-to-print version has a pump diameter of 25.5mm and it fits my 27mm pump perfectly. It should also fit smaller pumps. If you want a snug fit I would recommend a diameter 1.5mm lower than the diameter of your pump. Print with PETG or ASA or a strong material that can withstand being in the sun.
Adam también publica en
629 modelos adicionales en 4 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
