Thingiverse
Bike Sprocket Scraper
von sovtek
5
Downloads
8
Likes
0
Makes
Basic bike sprocket cleaner. Used to scrape off excess grease from the rear sprocket gears of most bikes. Teeth are just wide enough to fit between each gear.
Print Details
- Supports Yes
- PETG is better than PLA for this but either will work
- For the toothed area, make sure it is 100% infill or add walls until completely filled to make it the strongest it can be.
Print Details
- Supports Yes
- PETG is better than PLA for this but either will work
- For the toothed area, make sure it is 100% infill or add walls until completely filled to make it the strongest it can be.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
