BikeHanger

I designed a bike hanger, which can be used for small places. The hanger allows you to rotate the bikes so you can chose yours or the desired one without taking others off.


I printed it on Creality CR-10S, for 2 parts (Arm 1 and 2) you need to have printing bed 30x30.
I printed the STL with next configuration: [Layer, WallLines, Top/Botom, Infil]
Arm1 - 0.3, 5, 3, 20
Arm2 - 0.3, 5, 3, 20
BottomWheel - 0.3, 3, 3, 15
CableHolder - 0.1, 5, All, 100
Joint - 0.3, 5, 3, 35
WallBracket - 0.3, 5, 3, 35
Everything with support.

Then you would need a steel cable 3mm. Which connect from arm to CableHolder.
Also Arm2 have holes for cable, if you need extra support.

Bolts for one hanger:
2x M6x60 (Socket cap)
1x M6x70
1x M10x150
Wall screws:
3x M10 (Length depends quality of wall)
1x M6 (BottomWheel)


For Joint, WallBracket and CableHolder I used a PTEG, just for sure.