Binocular for modiFi helmet

This is another accessory for the modiFi helmet.

It was inspired by the clone trooper helmet mounted binoculars as seen in Battlefront II.
All parts shown in green on the first picture are included.

Additional Parts needed:
2x M3x30 mm flat head screws - to assemble binocular (inserted on the front)
2x M3x5 mm flat head screws - for small knobs on the underside
4x heat set M3 inserts - for screws on binocular
Visor made from clear tinted material (0,5-1 mm thickness recommended)
2x M4x20 mm flat head screw - to attach stalks to helmet
2x M4 nut (self locking) - to attach stalks to helmet
4x M4 washer
2x M4 spring washer - recommended for stalks

Instructions:
The level plates have an "O" for outside on one side, please place them accordingly.
The visor sheet can be cut by hand or laser cut using the .dxf as template. The 3D file is only for reference and does not need to be printed.
The stalks will benefit from using 100 % infill, the stalks are actually meant to be machined aluminiu