Thingiverse
Bipod Grip M-Lok
por Freeze654
3
Descargas
1
Likes
0
Makes
Hello everyone,
This was my first try designing a Bipod Grip myself to work with 3D printed parts and a rubber band only.
You can take a long rubber band and cut it. Make a knot as near as possible to one of the ends. Feet the long end through the round tunnel at the bottom of the grip so it comes out in the middle and attach the rubber band to the legs. To adjust the strengh of the rubber you can just pull out the knot and make a new one below.
In theory you could pull the legs out and they would stay in place until you release the hooks at the legs. It kinda works but the hooks have to be redesigned to hold more weight, Maybe someone can remix it if you have an idea to fix this.
The M-Lok uses 2 M5 x 14mm screws and 2 M5 nuts.
This was my first try designing a Bipod Grip myself to work with 3D printed parts and a rubber band only.
You can take a long rubber band and cut it. Make a knot as near as possible to one of the ends. Feet the long end through the round tunnel at the bottom of the grip so it comes out in the middle and attach the rubber band to the legs. To adjust the strengh of the rubber you can just pull out the knot and make a new one below.
In theory you could pull the legs out and they would stay in place until you release the hooks at the legs. It kinda works but the hooks have to be redesigned to hold more weight, Maybe someone can remix it if you have an idea to fix this.
The M-Lok uses 2 M5 x 14mm screws and 2 M5 nuts.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!