Biqu B1 - H2 Mount

Converting mount/mod for the Biqu B1 to use the Biqu H2 direct extruder.

Shout out to Bart Geldof, for the original files that made all this possible!

PETG for the Mount and Fan Duct. the Rest can be in PLA


-------------------------------------------------------------------------------------------------------------------------
This are my Notes for this design.

When Updating Firmware. Must Do this steps

E Steps = 932

Probe Offset
x = 31
y = -26

Home Offset
x = 0
y = 0

Driver Current
E = 800 mah (recommended for H2 by Biqu)

Print Acceleration : 500

Run - g28 , g29 after every firmware update, to activated BL Touch

Run - m500 to save

Run - M92, to double check values/ settings
-------------------------------------------------------------------------------------------------------------------------

Settings for Cura

Print Temp : 200
Bed Temp : 60
Layer Height : 0.2
Retraction distance : 1
retraction Speed : 40