Thingiverse
Bird Bath Bowl
von Snorriholm
24
Downloads
15
Likes
0
Makes
Birdbath bowl made to fit on a 26cm base, this file is only the bowl and not the pedestal seen in the pictures.
The model comes in 4 parts + 12 Dowel pins, once combined the bowl is 46cm in width and around 4 cm deep.
This is a very time consuming print, taking 60 hours to print with the settings that I used and about 800gr of PLA.
The model comes in 4 parts + 12 Dowel pins, once combined the bowl is 46cm in width and around 4 cm deep.
This is a very time consuming print, taking 60 hours to print with the settings that I used and about 800gr of PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
