Thingiverse
Bird Feeder 1
door 3DJC69
0
Downloads
0
Likes
0
Makes
The base may need to be rotated slightly to fit on smaller printers. It was designed to fit on an 8" x 8" or 200mm x 200mm platform rotated.
You will need a 15" piece of 1/8" cable and cable keeper. I used a Lead sinker and swaged it on the bottom end of the cable.
I used clear PLA for the windows. If you are handy, the windows can be cut out of 1/8" thick acrylic.
I suggest fitting the Roof Supports and Panels together and then using an appropriate adhesive glue the entire roof assembly so it can lift off and on easily, This is necessary to fill and empty the feeder.
You will need a 15" piece of 1/8" cable and cable keeper. I used a Lead sinker and swaged it on the bottom end of the cable.
I used clear PLA for the windows. If you are handy, the windows can be cut out of 1/8" thick acrylic.
I suggest fitting the Roof Supports and Panels together and then using an appropriate adhesive glue the entire roof assembly so it can lift off and on easily, This is necessary to fill and empty the feeder.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!