Thingiverse
Bird Feeder Broom Hook
door eckerj
8
Downloads
2
Likes
0
Makes
I like to put out bird feeders for all the various birds we have around here. However, I found that I needed to bring them in at night or else the raccoons and opossums would destroy the feeders.
Since we hang our feeders fairly high up trees, I was struggling to find an easy way of putting the feeders up and bringing them down. Some of the solutions I came up with were pretty entertaining (duct tape, coat hangers, etc), all of which were not very effective.
Then it dawned on me that I could easily model and 3D print a solution. This is the second revision of the parts. The first had a hexagonal post for the hook and a corresponding hexagonal hole in the adapter. The tolerances were way off and I figured it would be easier if the hook simply screwed into the adapter.
I did this in separate parts in case I ever wanted to make revisions to the hook, I wouldn't need to re-print the adapter.
This should print without any supports, however, I did model in a 0.2mm skirt on t
Since we hang our feeders fairly high up trees, I was struggling to find an easy way of putting the feeders up and bringing them down. Some of the solutions I came up with were pretty entertaining (duct tape, coat hangers, etc), all of which were not very effective.
Then it dawned on me that I could easily model and 3D print a solution. This is the second revision of the parts. The first had a hexagonal post for the hook and a corresponding hexagonal hole in the adapter. The tolerances were way off and I figured it would be easier if the hook simply screwed into the adapter.
I did this in separate parts in case I ever wanted to make revisions to the hook, I wouldn't need to re-print the adapter.
This should print without any supports, however, I did model in a 0.2mm skirt on t
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
