Bird Feeder

It's a bird feeder, print the top and the bottom. Get some 1/4 x 1/4 mesh and put it between, we went with about 12-inchs x 14 inches of mesh to make ours you can make it any size you wish, the hole is 4-inches in diameter.

So far the squirrels loves it..... birds too but our squirrels are eating the seeds like crazy.

Use a piece of wire between the two to hold it together and a piece of chain at the top allows you to open and fill the feeder easily.

The top needed supports to print I used a 0.8mm nozzle for a faster print, no support was needed for the bottom.