Thingiverse
Bird Feeder Window Standoff
door CPomeroy
8
Downloads
6
Likes
0
Makes
This was a quick design to hang the bird feeder from a window...Can't drill the window for a bracket!
Once printed, use a flame or some boiling water to heat the two bend points (boiling water is way easier).
One is between the legs to allow the lower pair to be twisted through 90 degrees, and one halfway up the bracket itself to allow another 90 degree twist. The second twist may not be necessary, but I wanted to have the two longer legs on the vertical axis.
The birds haven't found my feeder yet, so time will tell how stable it is in the face of serious use...!
Once printed, use a flame or some boiling water to heat the two bend points (boiling water is way easier).
One is between the legs to allow the lower pair to be twisted through 90 degrees, and one halfway up the bracket itself to allow another 90 degree twist. The second twist may not be necessary, but I wanted to have the two longer legs on the vertical axis.
The birds haven't found my feeder yet, so time will tell how stable it is in the face of serious use...!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
