Thingiverse
Bird Shower
von Laen
47
Downloads
40
Likes
0
Makes
This is a shower I made for our pet parakeet. It uses a cheap USB powered aquarium pump to pump water up a length of PVC pipe to a shower head.
Parts List:
* [A low flow rate pump](https://www.amazon.com/gp/product/B01CG2YE6K)
* 2 M3x10 screws.
* 2 M3 square nuts
* A length of 1/2" PVC pipe. I recommend 12-18 inches. Too high and it splashes too much.
* A 7 inch plate
* Rubber feet (optional)
* A casserole dish to serve as the water reservoir for the pump
Putting rubber feet on the base where the plate sits can keep it from sliding around.
Parts List:
* [A low flow rate pump](https://www.amazon.com/gp/product/B01CG2YE6K)
* 2 M3x10 screws.
* 2 M3 square nuts
* A length of 1/2" PVC pipe. I recommend 12-18 inches. Too high and it splashes too much.
* A 7 inch plate
* Rubber feet (optional)
* A casserole dish to serve as the water reservoir for the pump
Putting rubber feet on the base where the plate sits can keep it from sliding around.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
