Thingiverse
Birdcage parakeet platform
von luisiniguezh
8
Downloads
15
Likes
0
Makes
I created this platform and added sand paper on top to keep the parakeet toe nails in check, used Rotten's nut and bolt for the screw part.
Support is needed for the part of the platoform where the screws hang out but adjust the angle so the inside of the nuts don't get any support.
Support is needed for the part of the platoform where the screws hang out but adjust the angle so the inside of the nuts don't get any support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
