Thingiverse
Birdfeeder XL
por Merandey
7
Descargas
17
Likes
0
Makes
the larger version of my old birdfeeder design
LH: 0.2mm
no support (there is support on the strap)
infill for the top 40%
you need a buildplate at least with 22 x 22cm
with base1.1 I rised the outer edge and increased the gap
The base: birdfeeder_window:
If you print this base with a bright filament you could see the level of the birdfeed in the feeder!
Make sure the "window" is printed with a single line of filament!
LH: 0.2mm
no support (there is support on the strap)
infill for the top 40%
you need a buildplate at least with 22 x 22cm
with base1.1 I rised the outer edge and increased the gap
The base: birdfeeder_window:
If you print this base with a bright filament you could see the level of the birdfeed in the feeder!
Make sure the "window" is printed with a single line of filament!
Merandey también publica en
28 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
