Thingiverse
Birdhouse 03
von ividal
67
Downloads
66
Likes
1
Makes
Birdhouse to put on a wall or tree. If you want to hang just make a hole and that`s all.
It is made with two pieces (files): the case and the front. You will need a 5-6mm diameter wooden stick at least 15cm length, glue and two 5mm screws.
The printing lasts between 11 and 16 hours depending on the printing quality and configuration.
As always it can be improved
good luck
It is made with two pieces (files): the case and the front. You will need a 5-6mm diameter wooden stick at least 15cm length, glue and two 5mm screws.
The printing lasts between 11 and 16 hours depending on the printing quality and configuration.
As always it can be improved
good luck
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
