Bitaxe Skadis Mount / Standoffs

Simple and very sturdy Bitaxe Skadis Mount.
Tested with 204, but i think most other Bitaxe will work.

I used Brass Inserts M3x5.7x4.6 and M3 Screws M3x12.
Also there is a File to use it with M3 Standoffs.
One is with extra clearance.
If printing withouth extra clearance you need to cut the Standoff a little bit to make a flush fit.

First you need insert the "Hooks" into your Skadis and your desired position.
Then slide the "Bitaxe Holder" for above into the Hooks.
For Demonstration look at the th GIF (last picture).

If you end up with „Overheating“ problem with a bad Cooler, and this mount. It means that you didn’t insert all Brass Inserts in the same depth. So the board is a little bit flexing. In this case, just loose the lower bolts about 1 Turn

CAUTION:
Because of the thight fit i strongly recommend to mount your Bitaxe after you placed everything onto your Skadis. A little bit of force is required to click the Holder into the Hook.

Thanks to Kim-Janosch for t