Thingiverse
Bixler 3 motor mount
par Diymik
33
Téléchargements
20
Likes
0
Makes
Alternative to the stock motor mount.
Allows a standard type plate mount to fit. M3 screws, 34mm centre to centre measured across the middle.
Has the same 2deg angle, so pay attention when you install it, to get it the right way.
The motor should angle up more, so install with the short side of the mount on top.
You will need to trim some of the foam back. But it will use as much as, or more area to glue to, making it no weaker than the stock mount.
Allows a standard type plate mount to fit. M3 screws, 34mm centre to centre measured across the middle.
Has the same 2deg angle, so pay attention when you install it, to get it the right way.
The motor should angle up more, so install with the short side of the mount on top.
You will need to trim some of the foam back. But it will use as much as, or more area to glue to, making it no weaker than the stock mount.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
