Thingiverse
BL Touch Mount for E3D Clamp (Hypercube)
par BS3DP
121
Téléchargements
59
Likes
1
Makes
This is a basic mount for the BL Touch to be attached to the original E3D clamp made by Tech2C (clamp provided).
The mount is a simple design to just bolt onto the "fan" mount of the clamp. The fan mounts aren't used in the case of the hypercube as it uses a blower fan packed behind the hotend rather than next to the hotend.
Just use a few M3 nuts and bolts to hold the mount to the clamp and then again with the clamp to the main X carrage mount. Use a few M3 nuts and bolts to hold the bltouch in a fixed position.
Theres a small cutout on the part to pass the cables through from the bltouch to the top of the mount to allow you to plug them in.
Tech2C: http://www.thingiverse.com/Tech2C/about
The mount is a simple design to just bolt onto the "fan" mount of the clamp. The fan mounts aren't used in the case of the hypercube as it uses a blower fan packed behind the hotend rather than next to the hotend.
Just use a few M3 nuts and bolts to hold the mount to the clamp and then again with the clamp to the main X carrage mount. Use a few M3 nuts and bolts to hold the bltouch in a fixed position.
Theres a small cutout on the part to pass the cables through from the bltouch to the top of the mount to allow you to plug them in.
Tech2C: http://www.thingiverse.com/Tech2C/about
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
