Blackmagic ATEM Mini / Mini Pro Stand

The purpose of this stand is two-fold: It changes the angle for a better view of the controls, but more importantly removes the switcher off of the surface for better heat management. The ATEM Mini-Pro runs really hot, and elevating the switcher makes a substantial improvement in unit cooling when running it continuously.

This is a remix of two other stands, as I found that the angle of the ATEM top surface didn't align with the bracket at the rear of the unit, and created an uneven gap.

This version rotates and aligns the top "keyholes" and adds enough room underneath the ATEM where the brackets can slide on even with the mounting pads attached.

v3.1 - Thick Clip (Pics 4 and 5) - For a more robust connection the top clips are 3mm thick
v3.2 - Slim Clip (Pics 1,2,3) - Based on feedback, reduced the top clips to 2mm thick for a lower profile.
v3.4 - Boosted version (Pics 8,9,10) - Uses the same slim clips as v3.2, but the entire frame is about 6mm taller to account for using