Thingiverse

Blackout Mini H XT60 Mount

door el_penguino

23 Downloads

9 Likes

0 Makes

Male XT60 connector mount for Blackout Mini H quadcopter. Slides onto two rear 35mm spacers to accept female XT60 from LiPo. Hex spacer sockets are 6.1mm to allow for print swell. Pocket for XT60 will be a tight fit as designed - you will likely need to sand the sides of the connector housing to get it to fit snugly. Some manufacturers' connectors fit tighter than others. A bit of CA can be used to secure it. This design puts the solder lugs for the connector directly above the frame PDB LiPo pads.

250 quadcopter Blackout Blackout mini Blackout mini h Blackout Mini H Quad Blackout Mini-H fpv fpv250 mini quadcopter Quadcopter XT60 xt60 holder XT60 mount

Bron

Thingiverse

Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid

Eendelig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 1/3

Printer

FDM / FFF

Bestandsformaat