Blank Keycap for Razer Ornata V2

I tried very much to model this as close to the original as possible. The fitting part clips into the switch with a very slight amount similar to how the original fits and key presses seem to have a similar feel. While there exists a few different models of this key already, I found none of them were very accurate or true to the actual keycap's fitting so I made my own version. In my case, I printed this using an Anycubic Photon Mono X 6K. I have not tested it with an FDM printer but I am sure as long as you keep the line widths and heights reasonable, it should work without issue. If you do try this I would love feedback on the quality of the model.