Blanton's Bourbon Bottle Tea Light

This model I've split at the base to allow a tea light to be put inside, added a small neck to keep the rest of the bottle in place. I've split the decorative topper from the middle of the bottle to limit filament usage. If the topper was left on the bottle, you'd have long tree (or whatever) supports to get the fine details of the horseman on the topper. This way, the middle bottle section has minimal supports (inside it to support the top of the bottle) and the topper gets much shorter and finer supports. Just glue the topper on the middle section of the bottle, add a tea light and you are good to go. This version has the remains of the seal on the top (the rough edge around the topper) where the non-tea light version has the seal removed but has a removable topper that fits into the top of the bottle.

I recommend minimal infill just on the base section to give it more support for the bottom where the tea light sits. The middle and topper sections I printed with 2 walls and 0%