Thingiverse
Blinds turning knob
door usable_3d
4
Downloads
3
Likes
0
Makes
So i had a turning knob break off so i made a replacement part
My printer is pretty bad so i tried to make it pretty easy to print (flat bottom surface) and used a large adhesion brim to get it to print. Turned out better then the old yellow one :)
Use Concentric setting for bottom layers (looks better)
Clear off old material from the old rod and put this new one on with a drop of glue. With my settings it stays on even without glue (rod 3,85mm - hole in part is 4mm)
My printer is pretty bad so i tried to make it pretty easy to print (flat bottom surface) and used a large adhesion brim to get it to print. Turned out better then the old yellow one :)
Use Concentric setting for bottom layers (looks better)
Clear off old material from the old rod and put this new one on with a drop of glue. With my settings it stays on even without glue (rod 3,85mm - hole in part is 4mm)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
