Thingiverse
Bloom!
door Karzdan
4
Downloads
1
Likes
0
Makes
2 Part Loft testing the creation of a Flower like sculpture. There are 2mm holes at the bottom you can use small bits of filament (Everyone has a few inches of leftover filament) to glue them together.
The supports are optional. I designed them to prevent the ends of the outer petals from wobbling during printing. They should just snap off once done. Add them as you add the outer piece. Depending on the slicer you use, they should load exactly where they need to be. If your slicer places them on the print bed, raise them 5mm off of it. That's the height of the sculpture base.
The supports are optional. I designed them to prevent the ends of the outer petals from wobbling during printing. They should just snap off once done. Add them as you add the outer piece. Depending on the slicer you use, they should load exactly where they need to be. If your slicer places them on the print bed, raise them 5mm off of it. That's the height of the sculpture base.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!