Thingiverse
Blower Fan A8
by workdreamer
50
Downloads
29
Likes
0
Makes
The original blower fan from my A8 anet broke, so i decided to create a new design from scratch to fit a 60mm fan and reuse the original screws.
It was created to fit with all the current fan ducts, why the design as a cut section at the corner down left.
04/09/2017:
Edit: V2: I removed the cone, because it doesn't produce the expected air flow.
Edit: V3: Added one with slope..
It would be nice if someone could measure the air flow. :)
It was created to fit with all the current fan ducts, why the design as a cut section at the corner down left.
04/09/2017:
Edit: V2: I removed the cone, because it doesn't produce the expected air flow.
Edit: V3: Added one with slope..
It would be nice if someone could measure the air flow. :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
