BLTouch Cover Size Fixed

The original is a good height, but its a poor fit onto the BLTouch and flops down to the side, it just looks bad that way.

This re-mix is a snap fit onto the BLTouch, will not move at all. However, it is difficult to remove again without breaking and would almost definitely require you to unmount the BLT to do, that said, there is no reason to actually remove it anyway.

Fit by easing the bottom of the BLT into to cover, then snap the top onto the BLT above the wee circuit board, then slide up as far as it will go. Its a tight fit!