BLTouch Ender 3 V2 Mount

I really liked puturai's BLTouch mount (https://www.thingiverse.com/thing:4598663) but there were a couple of changes I wanted:

1. I wanted to use this BLTouch cover https://www.thingiverse.com/thing:4400925 and the brace on the original mount got in the way.
2. I wanted to adjust the nozzle/sensor offset down to about -1mm, where the original mount was around -3mm.

I removed the large brace and added smaller braces in different locations, and slid the mount arm to reduce my offset. We'll see how it holds up, but so far so good...

There are apparently 2 versions of the Ender 3 V2 - One of the versions does not have the mounting holes that this attaches to, so... :/

The nozzle to probe offset I'm using with this is X-40, Y-7